unleashed-firmware/documentation/js/js_gpio.md

GPIO module

The module allows you to control GPIO pins of the expansion connector on Flipper Zero. Call the require function to load the module before first using its methods. This module depends on the event_loop module, so it must be imported after event_loop is imported:

let eventLoop = require("event_loop");
let gpio = require("gpio");

Example

let eventLoop = require("event_loop");
let gpio = require("gpio");

let led = gpio.get("pc3");
led.init({ direction: "out", outMode: "push_pull" });

led.write(true);
delay(1000);
led.write(false);
delay(1000);

---

API reference

get

Gets a Pin object that can be used to manage a pin.

Parameters

• pin: pin identifier (examples: "pc3", 7, "pa6", 3)

Returns

A Pin object.

Pin object

Pin.init()

Configures a pin.

Parameters

• mode: Mode object:
  • direction (required): either "in" or "out"
  • outMode (required for direction: "out"): either "open_drain" or "push_pull"
  • inMode (required for direction: "in"): either "analog", "plain_digital", "interrupt" or "event"
  • edge (required for inMode: "interrupt" or "event"): either "rising", "falling" or "both"
  • pull (optional): either "up", "down" or unset

Pin.write()

Writes a digital value to a pin configured with direction: "out".

Parameters

• value: boolean logic level to write

Pin.read()

Reads a digital value from a pin configured with direction: "in" and any inMode except "analog".

Returns

Boolean logic level.

Pin.readAnalog()

Reads an analog voltage level in millivolts from a pin configured with direction: "in" and inMode: "analog".

Returns

Voltage on pin in millivolts.

Pin.interrupt()

Attaches an interrupt to a pin configured with direction: "in" and inMode: "interrupt" or "event".

Returns

An event loop Contract object that identifies the interrupt event source. The event does not produce any extra data.